OneUp Bash Guide
This item is currently not available.
Details
The OneUp Bash Guide was developed with input from EWS World Champions, Richie Rude and Jared Graves. Reinforced Nylon bash guards and a back plate cut from 8mm thick 7075-T6 aluminum, ensure that the OneUp Bash Guide can handle the biggest hits, but at a weight of only 102g (34T) you may forget it’s even there.
FEATURES:
• Install without removing your crank
• Fits ISCG 05
• Single tool install and adjustment
• Boost compatible
• Oval Compatible
• Stainless Steel hardware
• Includes 2 top guide pieces 1xBlack 1xGreen
• Includes 3 bash plates (28-30T, 32-34T, 36T)
• Patent Pending adjustment system
Weight: 87g 28-30T, 102g 32-34T, 105g 36T
Capacity: 28-36T
Capacity: 28-36T
Chainline: 5.5mm adjustment
Mount: ISCG05
Color: Black and Green top guide pieces included
Material: 7075 aluminum, top guide glass reinforced thermoplastic
GUIDE SETUP INSTRUCTIONS
1. Set chainring size tighten bolt to 3Nm
2. Hold backplate directly against ISCG05 tabs. Check for clearance between the back side of the bashplate/guide and the bike frame (use included 2.5mm spacers if necessary to space the backplate away from the frame).
2. Hold backplate directly against ISCG05 tabs. Check for clearance between the back side of the bashplate/guide and the bike frame (use included 2.5mm spacers if necessary to space the backplate away from the frame).
3. Rotate backplate until flat is horizontal and torque bolts to 5Nm
4. With crankset and chain installed, use spacer shim block to measure clearance between back plate and chain
5. Determine the corresponding number of chainline shims required
6. If more than 5 shims are required, install the supplied 6mm washers behind the backplate and return to step 2
7. Assemble top guide with spacers and tighten bolt to 3Nm
4. With crankset and chain installed, use spacer shim block to measure clearance between back plate and chain
5. Determine the corresponding number of chainline shims required
6. If more than 5 shims are required, install the supplied 6mm washers behind the backplate and return to step 2
7. Assemble top guide with spacers and tighten bolt to 3Nm
BASH REPLACEMENT INSTRUCTIONS
1. Remove Bash Guide from bike
2. Remove bolt retaining clip from rear bash plate bolt by pushing a 4mm hex through the bolt from the backside of the guide.
3. Remove Bash bolts using a 5mm hex
4. Select desired bash plate and reinstall bash bolts to 6Nm
5. Reinstall bolt retaining clip on the rear bash plate bolt
6. Reinstall Bash Guide onto bike
Videos
One Up Bash Guide
Reviews
